Подключение разводка кабеля Paravision SX1 to IDE Cable

Справочная информация и описание кабеля

Paravision SX1 to IDE

Can be used to connect a normal IDE harddisk to the Paravision SX1. Paravision was formerly known as Microbotics.

 (to the controller)
 (to the Harddrive)

37 PIN D-SUB MALE to the controller.
40 PIN IDC FEMALE to the harddisk.

Description D-Sub IDC Drive Reset 1 1 Data bit 0 2 17 Data bit 2 3 13 Data bit 4 4 9 Data bit 6 5 5 Ground 6 2 Data bit 8 7 4 Data bit 10 8 8 Data bit 12 9 12 Data bit 14 10 16 Ground 11+12 19 Ground 13+14 22 Ground 15+16 24 Ground 17 26 5V Power 18 n/c 5V Power 19 n/c Ground 20 30 Data bit 1 21 21 Data bit 3 22 22 Data bit 5 23 23 Data bit 7 24 24 Ground 25 40 Data bit 9 26 26 Data bit 11 27 27 Data bit 13 28 28 Data bit 15 29 29 I/O Write 30 23 I/O Read 31 25 Interrupt Request 32 31 Address bit 2 33 36 Address bit 1 34 33 Address bit 0 35 35 Chip Select 1 36 38 Chip Select 0 37 37

Note: Pin 18+19 (+5V) can be used to power the harddisk. But most harddisks require both +5V and +12V.

Contributor: Joakim Цgren, Kevin Hol? Source: ?

Copyright © The Hardware Book Team 1996-2004.
May be copied and redistributed, partially or in whole, as appropriate.
Document last modified: 2002-01-13






Рекомендуемый контент




Copyright © 2010-2017 housea.ru. Контакты: info@housea.ru При использовании материалов веб-сайта Домашнее Радио, гиперссылка на источник обязательна.